Extron Electronics ISM 824 - Manual (Page 162)

HTML Operation, cont’d
ISM 824 Integration Scaling Multiswitcher • HTML Operation 6-20
N Alternatively, if the new setting value is known, enter it directly into the field,
and press enter. The page refreshes, shows the new value, and the device is
updated.
For an aspect ratio other than the one currently displayed (16:9 or 4:3), click on the
blank radio button. The button fills and the device is updated to the new setting).
To save and recall presets do the following:
1 . Select either the User presets or Input presets drop down arrows as desired
(see figure 6-18).
N There are 3 user presets and 128 input presets. Each preset can be individually
configured for the range of adjustments available for that output card.
2 . Click Save to save current configuration to that preset number, or click Recall
to recall that preset as the current configuration.
To change any output configuration parameter, do the following:
1 . Within the Output Configuration section, select the setting to be changed, and
click on the drop down arrow. A drop down list appears. Scroll down the list
the desired value and click. The page refreshes and the new value is shown.
The device is updated to the new setting.
To change the advanced configuration settings do the following:
N The advanced settings for the ISM DVI and ISM HDSDI boards are test pattern
selection, film mode, blue mode, auto memory, and auto image.
1 . For test patterns, click the drop down arrow to see a list. Scroll down to the
required test pattern listed, and click. The display shows the selected pattern.
2. Within the Advanced Configuration section, click the check boxes of the
settings to be turned on or off as desired. The device is updated to the new
setting.