Extron Electronics ISM 824 - Manual (Page 63)

3-31 ISM 824 Integration Scaling Multiswitcher • Operation and Setup
N When the sub level is entered, the last selected input lights steady green. All
other input buttons flash green.
3 . Select the desired input by pressing its button. That button lights green, and
all other buttons flash green. The LCD screen indicates the input number
selected.
4 . Rotate either encoder to select the signal format for that input.
5 . Either select another input and repeat step 4, or press the Next or Menu
buttons to exit up to the top level menu. Alternatively wait 30 seconds for the
device to time out to the default display.
Output card configuration menu
This third menu level is reached by pressing the Menu button three times, or a
number of times until the Output Card configuration menu is shown in on the LCD
screen. This series of submenus is used to configure the optional ISM RGB, ISM
DVI, ISM HDSDI, and the ISM VS output boards.
N Universal Scaler and Video Scaler boards have a different set of submenus and
are discussed separately.
Press the Next button to bring up the first submenu (Select Output). The last
configurable output button selected lights green. If a different output type is to
be configured, press the output button for that board, or rotate either front panel
encoder to select the output.
ISM RGB board configuration menu
To configure the ISM RGB board using the Output Card configuration menus
(see figure 3-44), follow the steps in each submenu shown below.
The Output Card configuration submenus for the Universal Scaler board are; Select
Output, Input Setup, Output Config, User Presets, and Advanced Config.
N Within any submenu, press the Menu button to go directly to the top level
(Output Card Configuration) menu.
If no front panel buttons or encoders are used for 30 seconds, the device times
out and goes back to the default display cycle.
If an ISM RGB is installed, during power up a color bar test briefly appears on
the display device.