Operation and setup, cont’d – Extron Electronics ISM 824 User Manual
Page 76
Operation and Setup, cont’d
ISM 824 Integration Scaling Multiswitcher • Operation and Setup
3-44
Output Config submenu
Within this submenu, the resolution, refresh rate, output signal type, and sync
polarity can be selected and adjusted.
1
.
From the Input Setup submenu press Menu.
2
.
Press Next to bring up the Resolution submenu. In this submenu, the
resolution and refresh rate can be adjusted.
.
Rotate the left front panel encoder (
[
) to adjust the resolution value, and
rotate the right encoder (
{
) to adjust the refresh rate.
N
There are 12 output resolutions (see table) to choose from (720p, 1080i, and
1080p. The refresh rate is based on the resolution selected.
Resolution
24 Hz
25 Hz
30 Hz
50 Hz
59.94 Hz
60 Hz
720p
X
X
X
X
X
X
1080i
X
X
X
1080p
X
X
X
Figure 3-50 — ISM HDSDI output resolution/refresh rate table
3
.
Press Next to return to the upper level Output Config menu.
4
.
Press Menu to go to the next submenu (User Presets).
User Presets submenu
Within this submenu, up to 3 presets can be saved or erased.
1
.
From the Output Config menu, press Menu to enter the User Presets
submenu.
2
.
Press Next to go to the Save Preset menu.
Rotate either front panel encoder to select the preset (1, 2 or 3) to save the
current settings. Default setting is N/A.
3
.
Press Next to go to the Save Preset menu.
Rotate either front panel encoder to select the preset to be erased (1, 2 or 3).
Default setting is N/A.
4
.
Press Next to return to the User Preset menu.
5
.
Press Menu to go to the next submenu (Advanced Config).
Recall a User Preset
1
.
Press the Esc button to clear all active menus and reset the LCD to default
menu cycle.
2
.
Make an input tie to the desired scaler output to recall any one of the three
saved presets, numbered 1 to 3.
3
.
Press the output button. The LCD displays the message shown below.
Output Recalls
User Preset
4
.
Press the output button to cycle through the saved output presets (1, 2, or 3).
User Preset #2
Recalled
5
.
If no presets were saved previously, the following message is displayed.
No Valid User
Presets Found