Extron Electronics ISM 824 - Manual (Page 164)

HTML Operation, cont’d
ISM 824 Integration Scaling Multiswitcher • HTML Operation 6-22
To save and recall presets do the following:
1 . Select either the User presets or Input presets drop down arrows as desired
(see figure 6-19).
N There are 3 user presets and 128 input presets. Each preset can be individually
configured for the range of adjustments available for that output card.
2 . Click Save to save current configuration to that preset number, or click Recall
to recall that preset as the current configuration.
To change the output configuration (resolution, refresh rate, sync format, and
polarity) do the following:
1 . Within the Output Configuration section, select the setting to be changed, and
click on the drop down arrow. A drop down list appears. Scroll down the list
the desired value and click. The page refreshes and the new value is shown.
The device is updated to the new setting.
To change the advanced configuration settings do the following:
N The advanced settings for the Video Scaler card are top and bottom blanking,
blue mode, 2:2 pull down, edge smoothing filter, auto memory, auto image, and
enhancement mode.
1 . For top and bottom blanking adjustment, click the left (<) or right (>) arrows
to decrease or increase the blanking area.
N Alternatively, if the new setting value is known, enter it directly into the field,
and press enter.
2 . Within the Advanced Configuration section, click the check boxes of the
settings to be turned on or off as desired. The device is updated to the new
setting.
Special Characters
The HTML language reserves certain characters for specific functions. The switcher
does not accept these characters as part of preset names, the switcher’s name,
passwords, or locally created file names.
The switcher rejects the following characters:
{space (spaces are accepted in names)} + ~ , @ = ‘ [ ] { } < > ’ “ ; (semicolon)
: (colon) | \ and ?.