EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 67)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
58
o If only 3 digits are entered, the primary camera is selected
o If 4 digits are entered, the clip is selected according to the given
camera angle.
o If no clip matches the entry, no selection is done.
Note
ESC key can still be used at any time to clear the Name field.
9.3.10.2 H
OW TO
C
ALL A
C
LIP
B
ELONGING TO
A
NOTHER
M
ACHINE
T
HAN THE
O
NE YOU
A
RE
C
ONNECTED TO
1. Type either the first 3 or 4 digits of the ID, followed by a “/” and the
network number of the machine. Ex: 111/03 or 111A/03. To call a local
clip, no matter what machine you are connected to, type 00 as network
number. Ex: 111/00 or 111A/00.
2. Press F3.
9.3.11 H
OW TO
C
ANCEL A
N
ETWORK
C
OPY ON THE
VGA
Select the clip and press the CTRL+DELETE keys. A confirmation screen
comes up. “Cancel network copy? ESC: Do not cancel copy - ENTER: Cancel
copy”
If the Copy Clip option copies several cams of the same clip and some of
them have already been copied before the Cancel function, the cancel does
not do a delete of the copied files, it just cancels the cam(s) still copying or
to be copied of that clip. It does not cancel the copying of other clips.
The Cancel function remains possible even if the page where the clip is
being copied is protected.
9.3.12 H
OW TO
R
ESTRIPE THE
T
IME CODE OF THE
C
URRENT
C
LIP
To restripe the time code of the current clip, proceed as follows:
1. Recall the clip by moving the cursor on the desired clip and pressing
ENTER, or by clicking on it with the stylus.
2. Press ALT-T on the keyboard to call the SET TC function.
The Set Time Code screen is displayed (without TC Type field with
PAL – refer to note below):