EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 50)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
41
9.2.6 C
LEARING A
C
LIP
9.2.6.1 W
HICH
C
LIPS
C
AN BE
D
ELETED
?
Clips that are available on disks, or for which the record is in progress, can
be deleted.
The function key that corresponds to the clip location on the Remote Panel
must be green for the user to be able to delete it:
• Loaded clips can not be deleted.
• Clips included in a playlist or currently used by another operator, cannot
be cleared either in network mode.
In all cases, a warning message will appear.
9.2.6.2 H
OW TO
C
LEAR A
C
LIP
To clear a clip, proceed as follows:
1. Select the appropriate page and bank where the clip to be erased is
stored.
2. Press CLEAR, followed by the F_ key that corresponds to the clip.
Attention: In most cases, no confirmation is required and the clip will
be instantly deleted.
3. If the clip is protected or if the Confirm Delete Clip parameter is set
in the Setup menu, a warning message appears.
4. Press ENTER to confirm and the selected clip will be erased.
9.2.7 C
OPYING OR
M
OVING A
C
LIP
9.2.7.1 H
OW TO
C
OPY OR
M
OVE A
C
LIP
It is possible to copy or move a clip on the same server or to another server.
“Record in progress” clips can also be copied and moved.
To copy or move a clip from the Remote Panel, proceed as follows:
1. Select the original clip.
2. Select an empty location on the same machine.
3. A new menu appears on the LCD display of the Remote Panel, with
the corresponding message on the OSD of the output monitors:
Copy Clip 113 to Clip 141
Cam A B
[Menu]: Cancel
[Enter]: Confirm
COPY MOVE SHORT CLIP