EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 45)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
36
9. Clip Management
9.1 INTRODUCTION
9.1.1 C
LIP
S
TRUCTURE
A clip is defined by Short IN and Short OUT points. When referring to Short
IN and Short OUT points, the operators usually use the terms IN point and
OUT point.
When Short IN and Short OUT points are set, the system automatically write
protects a user definable length of material before and after the Short
IN/OUT points respectively, these are referred to as the guardbands.
For this reason, the IN point before the guardbands and the OUT point after
the guardband are called Protect IN point and Protect OUT point.
It is possible to trim a clip by redefining Short IN and Short OUT points.
If Short IN and Short OUT points are defined, only the fields between those
two points will be played if the sequence is recalled (the same applies when
the sequence is included in a playlist).
Fields between Protect IN and Short IN and fields between Short OUT and
Protect OUT (guardbands) can be reached with the jog. So the Short IN and
Short OUT points can be redefined.
Note
• Protect IN & Protect OUT points of a clip cannot be replaced
by new ones.
• Short IN & Short OUT points of a clip can be replaced by new
ones.
• Short OUT point is excluded. The clip freezes on previous field
when playing back (with Post-Roll disabled).
• (Short) IN & OUT are always on even fields. This is automatic.