EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 179)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
170
4. Press PLAY to start the playback.
During the playback, the material played on the hypermotion camera
is recorded into the server via the SDI connection.
18.3.3 G
ENERAL
P
ROCESS WITH
M
ULTIPLE
-B
LOCK
M
EMORY
The general recording and playback process when controlling the camera
using a multiple-block memory is the following:
1. Press the softkey (A to D) corresponding to the memory block (1 to 4)
on which you want to record the material.
2. Start the recording on the camera by pressing RECORD on the
Remote. The material start recording in loop mode on the given block.
3. When you want to start recording on another block, press TAKE.
4. Stop the recording in one of the following ways:
• Pressing Last cue will position the camera and cues to the first
recorded frame of the block.
• Jogging the dial will position the camera on the requested image.
• Selecting another block, which loads the first frame recorded on
this block in play mode.
5. Press PLAY to start the playback.
During the playback, the material played on the hypermotion camera
is recorded into the server via the SDI connection.
18.3.4 C
REATING A
C
LIP
W
ITH THE
M
ATERIAL FROM THE
H
YPERMOTION
C
AMERA
When the camera is replaying its content onto the EVS server, it is possible
to clip it automatically directly from the LSM Remote controlling the camera.
Using the IN and OUT keys and the F_ Keys, the operator can clip the
record train corresponding to the hypermotion camera and store it on a clip
position. That way it is possible to clip the hypermotion camera without
having the control on a PGM, and without waiting for all the content to be
recorded on the server.
When you have played back the material recorded on the hypermotion
camera, it is available in the record train of the camera defined in the
Recorder setting (p6.4, F2). You can then create clips with this material.
To do this, proceed as follows:
1. Come back to the LSM mode with SHIFT+D (in Hypermotion+LSM
mode) or use another Remote Panel (in Hypermotion only mode).
2. Load the relevant record train on the PGM.
3. Jog in the material and add a MARK IN, MARK OUT as usual to create
the requested clip.