EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 22)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
13
4.1.5 IN
This function defines the IN point of a clip. The key will light differently
depending in the following situations:
Green key The key lights green if an IN point exists but is not the
image you see.
Red key The key lights red if the on-air image is at this IN point. This
point can be entered while recording.
Flashing
(green or
red) key
In Split Audio mode, this key can be flashing green or
flashing red. Refer to the section 11.12 ‘Transition effects
and Split Audio’, on page 109 for more details.
4.1.6 OUT
This function defines the OUT point of a clip. This operates similarly to the
IN button.
Note
The OUT point (field) is always excluded. When playing a clip, it
will freeze on the field preceding the OUT point marked by the
operator.
M
ODIFICATION OF
C
LIP
IN / OUT P
OINTS
Select the clip that you wish to modify, use the jog dial to position the
material at the new IN or OUT point, and re-mark the IN or OUT point(s) as
required.
Important
When IN/OUT points are set and a clip is saved, the system
automatically write-protects a user definable length of material
before and after the IN/OUT points respectively. These are
referred to as the guardbands. Their duration can be set in the
Setup menu under «Guardbands» (page 2, F2) as required.
The duration of the guardband after the OUT point can be reduced
according to the quantity of video/audio material available when
saving the clip.
4.1.7 JOG KNOB
This function is used to accurately cue material.