EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 133)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
124
When the operator is not on a swap point, pressing CLEAR + IN/OUT brings
up a confirmation message to delete all swap points for the current clip.
11.13.6 N
AVIGATING
A
MONG
S
WAP
P
OINTS
When the operator is in Swap mode, the previous swap point can be reached
by pressing the Go to In button on the Remote. The next swap point is
reached by pressing the Go to Out button. The function works in loop mode.
11.14 REPLACE FUNCTION
11.14.1 I
NTRODUCTION
The purpose of the Replace function is to automate a routine used by
operators to create effects in a playlist: the operator would loop a section or
an entire playlist back to themselves and, during the playback, add some
effects externally (graphic insertion for instance) or internally (changing the
speed).
The operator would then edit the original playlist to insert the desired
section into the original playlist. That section would need to be inserted in
the playlist by matching the IN/OUT frames on the original playlist to the
new clip created with the re-recorded material.
The Replace function automates this process.
Note
The Replace function is not allowed on playlists containing “record
in progress” clips.
11.14.2 E
NTERING THE
R
EPLACE
F
UNCTION
A secondary menu with the Replace function has been added to the Playlist
Edit mode. Pressing Menu in Playlist Edit mode brings up the following
menu:
Clr Unav.
Replace MakeLoc Redo Undo
Select Replace in this secondary menu to enter the Replace function.
11.14.3 R
EPLACE
E
DIT AND
R
EPLACE
P
LAYBACK
M
ODES
Similar to the playlist, the Replace function has two modes:
11.14.3.1 T
HE
R
EPLACE
E
DIT MODE
This mode makes it possible to specify the following information for the
Replace: