EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 24)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
15
When a cue point exists for the current picture on the primary channel (the
CUE button lights red), pressing the BROWSE key allows the operator to
browse through all existing cue points by turning the jog dial.
When the current picture on the primary channel is neither a clip nor a cue
point, or if the operator is in Playlist mode, pressing the BROWSE key
allows him to browse inside the clips of the current playlist by turning the
jog dial.
4.1.12 INSERT
This function inserts a clip before or after (depending on the Setup menu)
the current position inside the playlist.
4.1.13 ENTER
This function appends clip(s) at the end of the current playlist. This is also
used to confirm saving of clips, and validate various options and messages.
4.1.14 MENU
This function allows the operator to gain access to the secondary menu.
SHIFT+MENU on the Remote gains access to the Main menu.
Also used as an ESCAPE key to cancel some options and messages.
4.1.15 CLEAR
This function clears the IN / OUT/ playlist / CLIPS / CUE points.
Note
• To clear one CUE point, recall the desired cue point and press
CLEAR + MARK key.
• To clear all cues: when current picture is not a CUE point,
press CLEAR + MARK key. A message appears to confirm the
command.
4.1.16 NETWORK
This function gives access to the clips and/or record trains of other
machines on the network. After the selection of the machine, the way of
selecting clips and camera angles is similar to clips selection on the local
LSM system. Refer to the Chapter 13 ‘Operating on XNet Network’, on page
139 for more details.