EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 52)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
43
the video drives, it simply creates a separate reference to the same video
material. This means that the capacity will not decrease when making copies
of clips on the same machine. It also means that deleted copies of clips will
not increase the available capacity of the server, as long as 1 instance of
the clip remains.
Copying clips across the network will reduce the capacity of the server
where the clip(s) is (are) copied by the duration of the clip(s).
9.2.7.4 A
BOUT
M
OVED
C
LIPS
When moving a clip using the Move function, the reference to this clip in
playlists will automatically be updated. This is very useful when an operator
wishes to re-organize his clips across different pages and banks, since
playlists will not be affected. If he copies the clips and then delete the
originals instead of using the Move function, the reference to the original
clips will be removed from the playlists when deleting these clips.
9.2.8 C
ANCELLING A
N
ETWORK
C
OPY
9.2.8.1 H
OW TO
C
ANCEL A
N
ETWORK
C
OPY ON THE
R
EMOTE
P
ANEL
When the clip is copying, its light flashes green. Pressing CLEAR + the
corresponding F_ key allows cancelling the network copy. A confirmation
screen comes up to cancel the network copy: “Cancel network copy ? MENU:
Do not cancel copy - ENTER: Cancel copy”
9.2.9 H
OW TO
S
HORTEN A
C
LIP
To shorten a clip, proceed as follows:
1. Recall the desired clip by pressing the corresponding F_ key.
2. Move the jog dial to browse the clip and reach to the desired Short IN
point.
3. Press the IN key to mark a new Short IN point. The new Short IN point
is instantly saved.
4. Move the jog dial to reach the desired Short OUT point.
5. Press the OUT key to mark a new Short OUT point. The new Short
OUT point is instantly saved.
Move the lever or press the PLAY key to play the clip. The replay will stop
at the new Short OUT point (or after the Short OUT point if the Post-Roll
mode is enabled).
GOTO IN and GOTO OUT
You can use Goto IN and Goto OUT functions to jump immediately onto
Short IN or Short OUT points respectively.