EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 101)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
92
11.5 ADDING CLIPS TO A PLAYLIST
11.5.1 P
OSSIBLE
M
ETHODS
You can add clips to a playlist in different ways:
• Adding clips at the end of the current playlist without entering the
Playlist Edit mode.
See the section 11.5.3 ‘How to Quickly Add Clips to the Current Playlist’,
on page 92.
• Inserting clips before or after the clip selected in the loaded playlist.
See the section 11.5.4 ‘How to Insert Clips into a Playlist’, on page 93.
• Adding one or more clips returned by a search at the end of the current
playlist.
See the section 11.5.5 ‘How to Insert the Result of a Clip Search into a
Playlist’, on page 93.
11.5.2 M
ODIFYING A
D
ISTANT
P
LAYLIST
Remote playlists are available as ‘Read Only’, and can not be edited. If you
want to modify a network playlist, you have to create a local copy on your
machine first. This operation is done instantly if the clips remain in their
original location. For details about copying playlists, refer to the section
11.8 ‘Copying a Playlist’, on page 98.
11.5.3 H
OW TO
Q
UICKLY
A
DD
C
LIPS TO THE
C
URRENT
P
LAYLIST
You can create a playlist very quickly. The experienced operator can include
a clip at the end of the playlist containing an action that happened seconds
before the playlist is played on air. To add clips quickly at the end of the
current playlist, you do not have to enter the Edit mode.
To add clips to the current playlist, proceed as follows:
1. Activate a playlist as the current playlist.
For more information, refer to the section 11.4.2 ‘How to Activate a
Local or Distant Playlist’, on page 90.
2. Recall the first clip for your playlist. For more information, refer to the
section 9.2.3 ‘Recalling a Clip’, on page 39.
3. Press ENTER on the Remote Panel.
The clip is added at the end of the current playlist.
4. Repeat as many times as necessary until the last clip is entered.