EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 40)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
31
7.1.2 O
PERATIONAL
M
ENU
The operational menu in Multi PGM mode gives access to the functions
detailed in the following paragraphs:
R
ST
C
AM
This function restores the position of cameras on the active channels: CAM
A on PGM1, CAM B on PGM2, etc.
Note
When a clip/playlist is loaded on a channel, switching back to Live
mode will recall the record train, which was last used on that
output. This avoids too frequent uses of the Rst Cam function.
S
YNC
T
O
This button allows you to synchronize the selected PGM in use with another
one. Press this button and then select the PGM to be used as a reference.
This function is not available with network trains.
T
OGGLE
/ A
LL
The Toggle function is only available in 3PGM mode:
• Toggle OFF: Selecting an output channel results in controlling that
channel and disables the control on others.
• Toggle ON: Selecting a channel will alternatively enable/disable the
control over that channel without changing the control on the others.
• All: This enables the control on all channels.
2
ND
CTRL
This function allows the operator to swap the control of one or several play
channels between the EVS remote and a third-party controller using the
Sony BVW75 or XtenDD35 protocol. Both controllers receive permanently the
status of the channel(s), but only one controller at a time is able to actually
control a channel. The secondary controllers are defined in Section 7 of the
remote Setup Menu.