EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 47)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
38
9.2.2 S
TORING A
C
LIP
9.2.2.1 H
OW TO
S
TORE A
C
LIP
To store a clip on a given location, proceed as follows:
1. Define a clip by marking the IN and/or OUT points
2. Select the page where the clip will be stored by pressing SHIFT +
PAGE + F_ key corresponding to the page.
Page 1 contains clips 110 to 199. Page 2 contains clip 210 to 299,
and so on.
3. Select the bank where the clip will be stored by pressing SHIFT + F_
key corresponding to the bank.
4. Select the location of the clip to store by pressing the corresponding
F_ key.
The clip is created on the specified location. The primary timecode of the
clip is the primary timecode defined on the train where and when the clip
has been created.
9.2.2.2 E
XAMPLE
To create the clip on the position n°212 (page 2, bank 1, clip location 2):
1. Press SHIFT+PAGE+F2 to select page 2.
2. Press SHIFT+F1 to select bank n°1.
3. Press F2 to select location n°2 on the selected page and bank.
Important
The AUTO-SAVE process automatically saves clips and playlists at
least every minute. With Multicam 5.03.25 or higher, playlists
are included in the AUTO-SAVE process. Exiting the software
(ALT+Q) or doing “Save Clips+Plst” from the main menu will also
save the clips and playlists.