EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 114)

EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
105
11.10.2 H
OW TO
T
RIM
C
LIPS INTO A
P
LAYLIST
Every playlist element can be trimmed independently of all other instances
of the same clip number.
1. Browse to the desired element in the playlist.
2. Re-mark a new Short IN or Short OUT.
If the clip duration is too short, clear the IN or OUT point by selecting
CLEAR and then set the new IN or OUT point at the desired position.
Note
Clearing restores the existing IN or OUT point to the end of the
guardbands of the clip.
11.10.3 H
OW TO
D
ELETE
P
LAYLIST
E
LEMENTS FROM A
P
LAYLIST
To delete a playlist element in a playlist using the Remote Panel, proceed as
follows:
1. While in Playlist Edit mode, scroll within the playlist to the element
that needs to be deleted.
If the Browse mode is active, the first frame will appear on the display
as each clip is scrolled through.
2. Select Delete from the Playlist Edit menu.
The selected element will be removed from the playlist. A confirmation
message will appear if that option has been enabled in the Setup menu.
11.10.4 H
OW TO
M
OVE AN
E
LEMENT
W
ITHIN A
P
LAYLIST
To move a playlist element within a playlist using the Remote Panel,
proceed as follows:
1. While in Playlist Edit mode, scroll within the playlist to the clip that
needs to be moved.
2. Select Delete from the Playlist Edit menu. The clip is sent to the
clipboard and loaded on the PRV channel.
3. Scroll to the location in the playlist where you want to insert the clip.
Remember that the position where the clip is inserted will depend on
the value of the setting ‘Insert in Playlist’ on P4.1, F5, that is to say
before or after the selected playlist element.
4. Press TAKE or INSERT on the Remote Panel to insert the clip from
the clipboard at the requested location.
The playlist element is inserted at the requested location.
If the playlist element has been trimmed before being moved, the element
will be reinserted in the new position with the new quardbands.