EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 27)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
18
4.1.21 PAGE
Use this key to select a new clips page. After pressing the SHIFT + PAGE
key, you must press a F_ key to select the corresponding page (1 to 10).
4.1.22 R
EBOOTING THE
S
YSTEM FROM THE
LSM R
EMOTE
«Hard Reboot»
In the event that the system needs to be rebooted, the process can be
accomplished from the Remote Panel. Keep in mind that doing this while
Multicam is running will of course force the Multicam application to close
abruptly, and up to 1 minute of the material being recorded and not clipped
could be lost.
To reboot, press the following key sequence,
Between step 3 and step 4, the RECORD button will flash GREEN and the
PAGE button will flash RED. Hitting the PAGE button will reboot the system.
Hitting the RECORD button will return to normal operation.
«Soft Reboot» from the keyboard
It is also possible to run a «soft reboot» which will exit the software and
return the user to the EVS Menu. Here, the software can be selected and
entered again without having to reboot the entire system. When running the
following procedure, the system will automatically save all recorded material
(record trains, clips, playlists) upon exit.
Hit ALT + Q on the keyboard or press F6 from the Main Menu, and confirm
with ENTER or cancel with ESC. You will exit the Multicam software and go
back to the EVS Menu.