ZyXEL Communications 70 Series - Manual (Page 796)

ZyWALL 5/35/70 Series User’s Guide
Appendix S Log Descriptions 796
Log Commands
Go to the command interpreter interface. Appendix M on page 754 explains how to access and
use the commands.
Configuring What You Want the ZyWALL to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyWALL is to record.
2 Use sys logs category to view a list of the log categories.
Figure 496 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 497 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the ZyWALL (you must do
this in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the ZyWALL’s log.
• Use the sys logs category display command to show the log settings for all of
the log categories.
• Use the sys logs display [log category] command to show the logs in an
individual ZyWALL log category.
ras> sys logs category
8021x access attack display
error icmp ike ipsec
javablocked mten packetfilter ppp
cdr pki tls remote
tcpreset traffic upnp urlblocked
urlforward wireless
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]