ZyXEL Communications 70 Series - Manual (Page 139)

ZyWALL 5/35/70 Series User’s Guide
139 Chapter 7 WAN Screens
7.7.2 Weighted Round Robin
To load balance using the weighted round robin method, select Weighted Round Robin in the
Load Balancing Algorithm field.
Figure 52 Load Balancing: Weighted Round Robin
The following table describes the related fields in this screen.
7.7.3 Spillover
To load balance using the spillover method, select Spillover in the Load Balancing
Algorithm field.
Configure the Route Priority metrics in the WAN General screen to determine the primary
and secondary WANs. By default, WAN1 is the primary WAN and WAN2 is the secondary
WAN.
Table 34 Load Balancing: Weighted Round Robin
LABEL DESCRIPTION
Active/Active
Mode
Select Active/Active Mode and set the related fields to enable load balancing on the
ZyWALL.
Load Balancing
Algorithm
Select a load balancing method to use from the drop-down list box.
Interface This field displays the name of the WAN interface (WAN1 and WAN2).
Ratio Specify the weighted ration for the interface. Enter 0 to set the ZyWALL not to send
traffic load to the interface.