ZyXEL Communications 70 Series - Manual (Page 501)

ZyWALL 5/35/70 Series User’s Guide
501 Chapter 32 Introducing the SMT
Figure 263 Initial Screen
32.2.2 Entering the Password
The login screen appears after you press [ENTER], prompting you to enter the password, as
shown below.
For your first login, enter the default password “1234”. As you type the password, the screen
displays an “X” for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your
ZyWALL will automatically log you out and display a blank screen. If you see a blank screen,
press [ENTER] to bring up the login screen again.
Figure 264 Password Screen
32.3 Navigating the SMT Interface
The SMT is an interface that you use to configure your ZyWALL.
Several operations that you should be familiar with before you attempt to modify the
configuration are listed in the table below.
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:A0:C5:01:23:45
initialize ch =1, ethernet address: 00:A0:C5:01:23:46
initialize ch =2, ethernet address: 00:A0:C5:01:23:47
initialize ch =3, ethernet address: 00:A0:C5:01:23:48
initialize ch =4, ethernet address: 00:00:00:00:00:00
AUX port init . done
Modem init . inactive
Press ENTER to continue...
Enter Password : XXXX
Table 181 Main Menu Commands
OPERATION KEYSTROKES DESCRIPTION
Move down to
another menu
[ENTER] To move forward to a submenu, type in the number of the desired
submenu and press [ENTER].
Move up to a
previous
menu
[ESC] Press the [ESC] key to move back to the previous menu.