Yamaha AW2400 User Manual
Page 89
Using the locator
89
AW2400 Owner’s Manual
Tr
anspor
t/Locate Oper
ation
9
The procedure for registering the current location in one
of the locate points, and then moving to that locate point is
as follows.
1
Move the song to the point that you want to
register as a locate point.
You can set locate points while the song is playing or
stopped.
2
Hold down the [SET] key and press the key
for the desired locate point.
The locate points correspond to the following keys.
1
[IN] key ......................... In point
B
[OUT] key ..................... Out point
C
[A] key .......................... A point
D
[B] key .......................... B point
E
[LOCATE] key 1–9........ Quick Locator points
F
RTZ [
] key ............... Relative Zero point
3
To move to a registered locate point, press
the corresponding key while the song is
stopped or playing.
The song will move to that location.
Registered locate points are displayed in the TRACK
screen Track View page as shown below.
The characters/numbers shown on the display corre-
spond to the locate types are as follows:
A
E
B
C
F
D
• The In point and Out point will be updated automatically when
you perform a record operation.
• If you want to change the Start point or End point, use the
EDIT screen Mark Adj. page. These points cannot be set
directly via the panel controls.
NOTE
Displayed Character/
Number
Locate Type
I
In point
O
Out point
A
A point
B
B point
L1–L9
Quick Locator points
S
Start point
E
End point
R
Relative Zero point
Locator icons
• Locate point settings are stored on the hard disk as part of
the song.
• Locate points can be adjusted as desired (
→ p. 91). Locate
points other than the Start point and End point may also be
erased (
HINT