Yamaha AW2400 - Manual (Page 209)

209
AW2400 Owner’s Manual
Utility functions
21
Chapter 21
Utility functions
This chapter explains the AW2400’s various utility functions.
The Oscillator page of the UTILITY screen lets you send the signal of the AW2400’s built-in test
oscillator to the desired bus.
To call this page press the Work Navigate section [UTIL-
ITY] as many times as necessary, or press the [F1] key
after pressing the [UTILITY] key.
This page contains the following items.
1 OSC ON button
When you turn this button on, the oscillator output will
immediately be sent to the specified bus. Use the
D–G
buttons to specify the bus to which the signal will be sent.
B LEVEL knob
Adjusts the output level of the oscillator.
C WAVEFORM
Selects one of the following oscillator signals.
• 100Hz button ................... 100 Hz sine wave
• 1kHz button ..................... 1 kHz sine wave
• 10kHz button ................... 10 kHz sine wave
• PINK NOISE button ........ Pink noise
• BURST NOISE button..... Burst noise (20-millisecond
pink-noise bursts as 4-sec-
ond intervals)
D BUS1 L/R, BUS2 L/R buttons
Sends the oscillator output to the Bus 1 L/R or Bus 2 L/R.
E AUX1–4 buttons
Send the oscillator output to AUX buses 1–4.
F EFFECT1–4 buttons
Send the oscillator output to effect buses 1–4.
G STEREO L/R buttons
Sends the oscillator output to the stereo bus.
H Level Meter
Displays the BUS 1–2, AUX 1–4, and EFFECT BUS 1–4
output levels.
Using the test tone oscillator
B
D
E
F
G
C
A H
• Pressing the [F1] key while holding the Display section [SHIFT]
key has the same affect as the OSC ON button.
HINT
• Be sure to lower the setting of the LEVEL knob before turning on
the oscillator to prevent sudden high-volume output.
NOTE
• Sine waves and white noise have a higher actual sound pressure
level than perceived by the ear, and may damage your speakers if
played at a high volume. Please use caution.
NOTE