beautypg.com

Rear panel – Yamaha AW2400 User Manual

Page 28

background image

AW2400 Owner’s Manual

Parts of the AW2400 and what they do

Introducing the A

W2400

28

2

1

[MIC/LINE INPUT] jacks 1–8 (XLR)

These are XLR-3-31 type balanced input jacks. Nominal input level is
from -46 dBu to +4 dBu. Connector wiring is as shown below.

B

[MIC/LINE INPUT] jacks 1–8 (TRS phone)

These are TRS phone type balanced input jacks. Nominal input level is
from -46 dBu to +4 dBu. Connector wiring is as shown below.

C

[INSERT I/O] jacks 1–2

These TRS phone jacks allow external signal processing gear to be inserted
into the signal received at the [MIC/LINE INPUT] jacks 1–2. Nominal
input level is 0 dBu, and the pin assignments are as follows:

D

[STEREO OUT] jacks

These are TRS phone type balanced output jacks that out-
put the signals of the stereo bus. Nominal output level is
+4 dBu.

E

[MONITOR OUT] jacks

These are TRS phone type balanced output jacks that out-
put the monitor signals of the stereo bus or the solo bus.
Nominal output level is +4 dBu.

F

[OMNI OUT] jacks 1–4

The unbalanced phone jacks output the signals specified in
the PATCH screen Output page. Nominal output level is 0
dBu.

G

[PHONES] jack

This is a 1/4" TRS phone output jack for connecting your
headphones for monitoring. This jack always outputs the
same signal as the [MONITOR OUT] jacks.

H

[POWER] switch

Switches the power ON and OFF.

I

[AC IN] connector

Connect the supplied power cord to this connector.

J

Ground Screw

For maximum safety the ground screw should be properly
connected to a confirmed ground point. Proper grounding
will also ensure minimum hum, noise, and interference.

Rear panel

4

G

E

F

H

I

K

J

O

P

Q

L

M

N

B

1

C

Male XLR connector

1 (ground)

3 (cold)

2 (hot)

1/4" TRS phone plug

Ring (cold)

Tip (hot)

Sleeve (ground)

OUT

IN

Sleeve (ground)

1/4" TRS
phone plug

1/4" TRS
phone plug

1/4" TRS
phone plug

Tip (OUT)

Sleeve (ground)

Tip (IN)

Sleeve (ground)

To the INSERT I/O
jack of the AW2400

To the input jack of the
external processor

To the output jack of the
external processor

• When switching the power of the AW2400 ON or OFF, always fol-

low the “Turning the power on/off” procedures described on
page 38.

NOTE

• Use only the supplied power cord for this unit. The use of an

inappropriate replacement may be a fire and electrical shock
hazard.

CAUTION