Yamaha AW2400 - Manual (Page 114)

AW2400 Owner’s Manual
Using external effects with the AUX buses
AU
X
114
13
● Signal Flow When Using an External Effect Processor
9
Press the Selected Channel section [PAN/
EQ] key so that its indicator lights, then
press Selected Channel knob 1 as many
times as necessary to display the PAN/EQ
screen Input/RTN page.
10
Set the input channel 3 and 4 pan controls
fully left and right, respectively.
This ensures full stereo effect from the stereo effect
processor. You could also pair inputs 3 and 4 for easy
stereo control.
11
Raise the [STEREO] fader to the 0-dB level
and, while playing back the song, adjust the
input level of the external effect processor
as well as the input levels of input channels
3 and 4 using the [GAIN] knobs.
If necessary return to step 7 and readjust the send lev-
els from the track channels to the AUX1 bus as
required. You can also adjust the AUX1 bus master
level by selecting the appropriate layer and fader via
the Layer section [MASTER] key and channel [SEL]
key, or by using the CH VIEW screen View page LVL
knob.
12
Turn the RECORD screen Mixdown page
REC button on and begin the actual mix-
down process.
Track 1
Track 2
Track 3
Track 4
Track 5
x Number of
play tracks
x Number of
play tracks
Mixer section
Stereo bus
AUX bus 1
[MIC/LINE
INPUT]
jacks 3/4
[OMNI OUT]
jack 1
Effect Processor
T
rac
k c
hannels
A
UX Bus master c
hannel
Input c
hannels
Stereo output c
hannel
• With this setup be sure to set all AUX send levels for input
channels 3 and 4 to – ∞ to prevent feedback.
NOTE