Yamaha AW2400 - Manual (Page 112)

AW2400 Owner’s Manual
AUX Send Level Adjustment
AU
X
112
13
● AUX screen Input/RTN page
1 INPUT field
Adjusts the AUX send levels for input channels 1–16.
The PRE/POST buttons below each knob can be used
to select pre-fader or post-fader send.
B RETURN field
Adjusts the AUX send levels for effect return channels
1–4. The PRE/POST buttons below each knob can be
used to select pre-fader or post-fader send.
● AUX screen Track page
1 TRACK field
Adjusts the AUX send levels for track channels 1–24.
The PRE/POST buttons below each knob can be used
to select pre-fader or post-fader send.
4
Move the cursor to a knob and use the
[DATA/JOG] dial or the [INC]/[DEC] keys to
adjust the send level.
The range is from – ∞ – +10 dB.
5
To set the point from which the AUX send
signal will be derived in each channel,
move the cursor to the appropriate PRE/
POST button and press the [ENTER] key to
select either PRE (pre-fader: the signal is
sent from a point before the channel fader)
or POST (post-fader: the signal is sent from
a point after the channel fader).
6
To adjust send levels to a different AUX
bus, press the corresponding Selected
Channel knob to switch to the appropriate
screen, then adjust the send levels as
described in steps 4 and 5, above.
Selected Channel section knobs 1–4 can be used to
directly adjust AUX send levels.
1
Use the Layer section keys, [INPUT SEL]
keys, and [SEL] keys to select the channel
for which AUX send level is to be adjusted.
2
Press the Selected Channel section [AUX]
key so that its indicator lights.
The AUX screen will appear.
3
Rotate Selected Channel
knobs 1–4.
This will adjust the AUX send
level for the channel selected in
step 1.
A
B
A
• While the [AUX] key is lit you can press one of the Selected
Channel knobs repeatedly to switch between the display
pages for the corresponding AUX screen. For example, press-
ing Selected Channel knob 1 repeatedly will switch back and
forth between the AUX1 screen Input/RTN page and the Track
page.
• By pressing the [F1] or [F2] key while holding the Display sec-
tion [SHIFT] key you can simultaneously set all channels in
the display to PRE ([F1]) or POST ([F2]).
HINT
• Knobs can also be selected via the Layer section keys,
[INPUT SEL] keys, and [SEL] keys.
• Move the cursor to a knob and press the [ENTER] key to turn
that AUX send on or off.
HINT
■ Adjusting AUX send levels via
the Selected Channel section
• If AUTO DISPLAY function is disabled the AUX screen will not
appear automatically when step 2, above, is performed, but
the AUX send levels can still be adjusted by rotating the
Selected Channel knobs.
• If AUTO DISPLAY function is disabled a popup window will
appear when a value is adjusted for easy visual confirmation,
regardless of the display that is showing at the time.
HINT