Midi synchronization message setup – Yamaha AW2400 User Manual
Page 198
198
AW2400 Owner’s Manual
MIDI
20
F
OTHER field
MIDI messages other than program change and control
change messages are set up here.
• ECHO button (TX)........ Received MIDI messages
other than program and control
change are re-transmitted
(“echoed”) via the MIDI OUT/
THRU connector (or USB con-
nector or digital I/O card output
port).
G
REMOTE OUT box
Selects the connector/port via which MIDI messages will
be transmitted when the MIDI Remote function is active
(when the REMOTE screen is showing). Refer to
page 204 for details on the MIDI Remote function.
H
THRU box
Specifies the connector/port for “THRU” output of MIDI
messages received via the MIDI IN connector (or USB
connector or digital I/O card input port). If “MIDI” and
“USB 1” are selected for the two THRU boxes, THRU
output will be as follows:
• Messages received at the MIDI IN connector will be
THRU output via the USB output port 1.
• Messages received at the USB input port 1 will be
THRU output via the MIDI OUT/THRU connector.
MIDI messages generated by the AW2400 itself are not
transmitted via connectors/ports selected for THRU out-
put.
The MIDI screen Setting 2 page allows selection of MIDI messages used for synchronization
with external equipment (MTC and MIDI clock) as well as messages used for remote control.
To call this page press the Work Navigate section [MIDI]
key as many times as necessary, or press the [F2] key after
pressing the [MIDI] key.
This page contains the following items.
1 MMC field
Specifies how MMC will be transmitted/received.
B
MMC OFF button
Engage this button (it will appear inverted) to disable
MMC transmission and reception.
C
MMC MASTER button
When this button is turned on the AW2400 functions as
MMC master, and the appropriate MMC commands will
be output via the MIDI OUT/THRU connector (or USB
connector or digital I/O card output port) when the trans-
port is operated. Turn this button on when you want to
remotely control external equipment from the AW2400.
D
MMC SLAVE button
When this button is turned on the AW2400 functions as
MMC slave, and will respond to appropriate MMC com-
mands received via the MIDI IN connector (or USB con-
nector or digital I/O card input port). Turn this button on
when you want to remotely control the AW2400 from
external equipment.
• The same connector/port as selected in the PORT field or THRU
box cannot be selected here.
NOTE
• The same connector/port cannot be specified for both boxes.
• The same connector/port as selected in the PORT field or
REMOTE OUT box cannot be selected here.
NOTE
MIDI Synchronization Message Setup
F
A
B
C
H
G
J
I
K
E
D