Yamaha AW2400 - Manual (Page 60)

AW2400 Owner’s Manual
Applying EQ To an Input Signal
Tr
ac
k recording
60
6
The AW2400 provides versatile 4-band equalizers on every channel that can be directly operated
via the Selected Channel section keys and knobs.
This section describes the procedure for applying EQ to input channels 1–8.
1
Press the Layer section [IN 1-8] key so that
its indicator lights, the press the [SEL] key
for the channel to which EQ is to be
applied.
2
Press the Selected Channel section [PAN/
EQ] key so that its indicator lights. Press
Selected Channel knob 1, 2, 3, or 4 and the
PAN/EQ screen will appear.
3
Press the Display section [F3] key to call
the EQ/Att. page.
The EQ settings are available via this page.
4
To turn the EQ on, move the cursor to the
EQ ON/OFF button and press the [ENTER]
key.
5
Press the Selected Channel section [LOW],
[LO-MID], [HI-MID] or [HIGH] key to select
the EQ band to be adjusted.
6
Use Selected Channel section knobs 2–4 to
adjust the EQ as required.
When the [PAN/EQ] key is lit, Selected Channel
knobs 2–4 perform the following functions: knob 2
adjusts the Q, knob 3 adjusts the center frequency, and
knob 4 adjusts the gain of the selected band.
7
Repeat steps 5 and 6 to set all bands as
required.
Applying EQ To an Input Signal
• The [INPUT SEL] 1–8 keys can also be used to select an
input channel for equalization.
HINT
EQ ON/OFF button
• Pages can also be selected by repeatedly pressing Selected
Channel section knobs 1–4.
HINT
• In addition to the ability for fine EQ control as described
above, the supplied EQ library contains preset EQ setups for
a variety of instruments that can be recalled and used or
edited as required. Refer to “Pan, EQ, and Dynamics Pro-
cessing” on page 147 for details.
HINT