Yamaha AW2400 User Manual
Page 103
Input signal patching
103
AW2400 Owner’s Manual
P
atching and signal flo
w
11
5
In the same way, select other input chan-
nels as recording-sources.
6
Move the cursor to the
symbol for the
desired recording-destination track, and
press the [ENTER] key.
A popup window will appear, asking you to confirm
whether you want to initialize the channel parameters.
7
Move the cursor to the OK button and press
the [ENTER] key.
You can select up to four tracks as recording-destina-
tions. Bus 1L/bus 2L can be connected to odd-num-
bered tracks, and bus 1R/bus 2R can be connected to
even-numbered tracks. The [SEL] key of the con-
nected track channels will blink red, indicating that
they are in record-ready mode.
You can select the bus signal to be input by repeatedly
pressing the [ENTER] key in the same way as for the
input channels.
For example if you move the cursor to the
symbol
for track 1 and repeatedly press the [ENTER] key, the
screen will change as follows.
8
Proceed with recording.
For details on recording, refer to “Track recording” (
• You can also perform steps 3–4 by repeatedly pressing the
[INPUT SEL] key (or the input channel’s [SEL] key).
• The [INPUT SEL] keys always control input channels 1–8,
regardless of the settings of the Layer section.
• If an input channel is selected as a recording-source, its
assignment to the stereo bus will automatically be turned off,
and it will be connected via bus 1 or bus 2 so that it can be
monitored by the track channel.
HINT
C
No Connection
B
Connected to Bus 2 L
A
Connected to Bus 1 L
To
A
• You can also perform this operation by repeatedly pressing
the track channel’s [SEL] key.
• EQ and dynamics setting will be set to a flat state for track
channels corresponding to tracks that are selected as a
record destination.
• When a single track is selected as the record destination the
pan of the corresponding track channel will automatically be
set to center. When paired tracks are selected as the record
destination the pan settings of the odd- and even-numbered
tracks will automatically be set to left and right, respectively.
• To cancel all connections, move the cursor to the SAFE but-
ton and press the [ENTER] key.
HINT
• The track numbers of muted tracks will be displayed as
(mute), but you can still record to muted tracks.
• Since 24-bit songs can have a maximum of 12 play tracks (
p. 165), tracks 13–24 are muted and will not play back.
NOTE