Yamaha AW2400 User Manual
Page 34
AW2400 Owner’s Manual
Basic operation of the AW2400
Introducing the A
W2400
34
2
2
Press the SELECTED CHANNEL section [DYN], [AUX],
[EFFECT], or [PAN/EQ] key so that its indicator light,
according to the parameters you want to control.
With the default settings the screen corresponding to the pressed key will
appear automatically. The display will not change if the UTILITY screen
Preference page AUTO DISPLAY button is set to OFF (
The parameters that can be controlled by the SELECTED CHANNEL
knobs are as follows:
3
Rotate SELECTED CHANNEL knobs 1–4 to adjust the cor-
responding parameters as required.
If the UTILITY screen Preference page AUTO DISPLAY button is set to
OFF, a popup window showing the corresponding parameter name and
the value will appear while the knob is being operated.
Selected Key (Lit)
Knob 1
Knob 2
Knob 3
Knob 4
[DYN]
Multiple compressor parame-
ters, or the last parameter
operated, depending on the
control status.
Compressor threshold.
Compressor ratio.
Compressor gain.
[AUX]
Send level from channel to
AUX 1.
Send level from channel to
AUX 2.
Send level from channel to
AUX 3.
Send level from channel to
AUX 4.
[EFFECT]
Send level from channel to
EFFECT 1.
Send level from channel to
EFFECT 2.
Send level from channel to
EFFECT 3.
Send level from channel to
EFFECT 4.
[PAN/EQ]
Pan
Equalizer Q.
Equalizer frequency.
Equalizer gain.
• After selecting a channel, press the SELECTED CHANNEL [VIEW] key to call
the CH VIEW screen where you can edit the channel signal routing and all of the
channel parameters. Refer to page 105 for details on the CH VIEW screen.
HINT
• The parameter controlled by SELECTED CHANNEL knob 1 when the [DYN] key
is engaged depends on the current operating status (
• If you operate SELECTED CHANNEL knob 1 immediately after recalling a setup
from the compressor preset library, multiple compressor parameters will be
adjusted simultaneously, changing the overall effect of the compressor (the type
of change depends on the recalled preset library setup).
• When individual compressor parameters for a channel have been adjusted via
the DYNAMICS screen, the last parameter adjusted is assigned to SELECTED
CHANNEL knob 1 (the last-adjusted parameter is individually retained for each
channel).
NOTE