5 find the software version number, 6 technical support, service and repairs, 7 upgrading the 8000i system – NorthStar Navigation NorthStar 8000i User Manual
Page 191
Northstar 8000i Operation Manual
191
3. Select
+ System to display a list of system options.
4. Select
Calibrate next to Calibrate Touch Screen.
5. Follow the instructions on the screen. (If you want to be able to select
the buttons at the bottom of the screen easily, you must touch the
center of the targets.) When the cursor follows your finger across the
screen, select the green arrow. This ends the calibration process.
6. When you are finished, select – System.
41.5
Find the software version number
To find the software version number:
1. Select
Display from the top of the screen.
2. Select Setup from the control panel.
3. Select
+ Installation to display a list of installation specification
options.
4. Select
the
Software Version Information button. The
Software Versions box is displayed with all your system information.
5. When you are finished, select OK then select – Installation.
41.6
Technical support, service and repairs
Northstar products are manufactured and serviced by BNT Marine Electronics.
The 8000i is covered by a warranty which is supplied as a separate document.
If you need technical support, or answers to other questions after you've followed
the instructions in this manual, you can:
•
contact your Northstar distributor or
•
see the inside back cover of the manual or
•
visit www.northstarnav.com.
Before you make contact, be sure to have:
•
the serial number of the hardware (usually shown on the rear of the unit).
•
the version number of the software (see "Find the software version number"
page 191)
When you describe the problem, be as complete and as accurate as possible.
If you are requested to return the 8000i for repair, you may want to save your
waypoints and routes libraries.
41.7
Upgrading the 8000i system
Upgrades to 8000i system can be implemented very easily. Upgrades are available
from the Northstar website. The upgrade is a single file that is downloaded and
copied to the root of a USB pen drive. The upgrades can apply to all 8000i
processors and the following network modules
•
Northstar 8000i 1 kW Network Sounder.
•
Northstar 8000i Radar (all models)