NorthStar Navigation NorthStar 8000i - Manual (Page 161)

Northstar 8000i Operation Manual 161
29.10 Reset an alarm
The 8000i resets some alarms, such as the Waypoint Arrival alarm and the
Waypoint Arrived End of Route alarm, automatically after a set time period.
The 8000i resets other alarms automatically when the sensor data is within the
trigger settings again.
29.11 Set an anchor alarm
When you're at anchor, you can set the anchor alarm to trigger if your vessel
moves outside of a specified radius around your anchor position.
This works only when an anchor alarm radius is specified.
To set the anchor alarm:
1. Select
Alarms to show the entries in the Alarm Log.
2. Select
Set Anchor Alarm to display the Anchor Setup box.
3. Select the Anchor Alarm. The Alarm button shows the current
setting. If this is Off, select the button to toggle it On.
4. The
Set Upper button shows the anchor alarm radius. Select this if
you want to change the setting.
5. Change any of the other settings if you want.
6. When you are finished, select Return.
7. The 8000i immediately creates a waypoint at your vessel's current
position and indicates this with an anchor icon.
Now, if your vessel moves outside of the specified radius around your anchor
position, the anchor alarm will be triggered.