Interlogix TruPortal User Manual
Page 40
Configuring the System
28
TruPortal Software User Guide
c.
Select an Aux Relay On Time.
16.
Configure the sensor
for:
•
Door Contact sensor
•
Request to Exit button or sensor
•
Aux input from the Extended Request to Exit or magnetic lock contact sensor
•
Tamper circuitry
Note:
The Aux and Tamper inputs listed above do not apply to doors connected to IPSDCs.
17.
Click [Accept Changes].
18.
Repeat for each door.
Configure a Door for Magnetic Locks
• WARNING! •
When configuring a door with magnetic locks, it is important to use the “Mag
Lock Bond Sense” option to prevent the door magnets from prematurely
activating and slamming the door shut, potentially causing injury.
1.
Select System Administration > Devices.
2.
Expand the tree below the System Controller.
3.
Expand the tree below the Door Controller.
4.
Select the Door to configure.
Note:
Some fields will not appear on the Devices page if a door is connected to an IPSDC,
which does not support auxiliary input/output types or tamper input points. Refer to the
IP-based Single Door Controller Quick Reference to learn about modifying jumper
settings for input types.
5.
6.
This is the amount of time the door will remain unlocked so the person can open it.
7.
8.
.
This is the amount of time the door can remain open so the person can pass through.
9.
Select a Door Strike Mode.
•
10.
(Optional) Select a Linked Camera if one is positioned to monitor the door.
11.
12.
if the door is wired for it.
13.
(Optional) If
prevent the door strike from energizing when the Request to Exit contact closes.
14.
(Optional) Select any alarms the door is wired for:
•
15.
” from the
list.