Interlogix TruPortal - Manual (Page 113)

TruPortal Software User Guide 101
Error, Warning and Event Messages
Fuse Events
Device Events
* Not applicable to built-in door controller
Device Communications Failed/Restored
Used to indicate communication errors with downstream devices. Occurs when communications
between the RS-485 SNAPP bus and a configured downstream device are lost or established.
Device will always show which module is affected.
Device Failed/Restored
Used to indicate general issues with downstream devices. Occurs when any device tamper input
changes state (including External/Wall Tamper, but not Door Tamper), or when a VBUS
communications error is detected. Device will always indicate Controller. For tamper events,
there will be corresponding tamper event for the device. For VBUS error events, there is no way
to report which device has the VBUS error, so there is no corresponding event to show which
device has the VBUS error.
System Trouble/Restored
Used to indicate general issues with the System. Occurs when External/Wall Tamper changes
state. Device will always indicate the System Controller. This event may be used in the future to
identify other trouble conditions.
Event Code Event Description
Event 14651 Fuse Tripped
Event 14652 Fuse Restored
Event Code Event Description Device
Event 4105 Device Communications Failed Door Controller, I/O Expander
Event 4106 Device Communications
Restored Door Controller, I/O Expander
Event 4107 Tamper Alarm* Controller, Door Controller, I/O Expander
Event 14622 System Trouble Controller
Event 14623 System Restored Controller
Event 14628 Device Failed Controller
Event 14629 Device Restored Controller
Event 14643 Tamper Restored* Controller, Door Controller, I/O Expander