Pre-defined operator role permissions – Interlogix TruPortal User Manual
Page 123
TruPortal Software User Guide
111
Pre-Defined Operator Role Permissions
To enable the ICT temporarily:
1.
Press and hold SW4 until D19 (i.e., the Watchdog LED) turns ON. Allow up to five (5) seconds
for D19 to turn ON. (See the IP-Based Single Door Controller Quick Reference for switch
locations.)
2.
After D19 is ON, release SW4.
3.
D19 turns OFF when the ICT is manually enabled.
The ICT is now enabled until the controller reboots.
To enable the ICT permanently:
1.
Complete the steps to enable the ICT temporarily, as listed above.
2.
Log on to the ICT.
3.
From the Controller Parameters menu, select Other Parameters.
4.
Deselect Disable Integrated Configuration Tool, then click OK.
5.
To make this selection permanent, click Save, Apply Changes, then Restart Controller.
The IPSDC performs a system reboot automatically and the ICT is permanently enabled.
To disable the ICT:
1.
Log on to the ICT.
2.
From the Controller Parameters menu, select Other Parameters.
3.
Select Disable Integrated Configuration Tool, then click OK.
4.
To make this selection permanent, click Save, Apply Changes, then Restart Controller. The
controller performs a system reboot automatically and the ICT is permanently disabled.
Pre-Defined Operator Role Permissions
on page 43, an operator role is a group permissions
policy that can be used to expand or limit the User Interface pages that users can see, as well as the
actions that users can perform in the System.
The various permission levels include:
•
None: The operator cannot visit or view this page.
•
View: The operator can see the page or data, but cannot make changes or execute commands.
•
Modification: The operator can change settings.
•
Execute: The operator can execute commands.
The following table provides the default permission levels for the System.
Feature
Permission
Levels
Administrator
Operator
Guard
View
Only
Dealer
Access
Levels
None, View,
Modification
Modification
Modification
View
View
Modification
Action
Triggers:
Administration
None, View,
Modification
Modification
View
View
View
Modification