Connecting to a local client workstation or lan, Installing an enrollment reader – Interlogix TruPortal User Manual
Page 18
Installing Hardware
6
TruPortal Software User Guide
Connecting to a Local Client Workstation or LAN
The System Controller can be connected directly to a local client workstation or to a Local Area
Network (LAN). There are two RJ-45 100BaseT Ethernet jacks on the System Controller. Port 1 is
configurable; Port 2 has a fixed IP (Internet Protocol) address, 169.254.1.200. Refer to the System
Controller Quick Reference Guide to identify the jacks.
If connecting the System Controller directly to a local client workstation, use the static Ethernet jack
and a Category 6 (CAT6) Ethernet cable. If connecting to a LAN, use the configurable Ethernet jack
and a CAT6 Ethernet cable. Consult the site network administrator to determine how the System
Controller should be configured, as discussed in
Note:
If multiple network appliances use a single network drop by means of a switch or small
router, make sure there is not more than one switch or router between the System
Controller and the network drop.
Installing an Enrollment Reader
If planning to use the optional enrollment reader (TP-RDR-LRN) to read credential data, install and
configure the reader on a client workstation according to the manufacturer’s instructions. See
In:
Out:
In:
Out:
In:
Out:
In:
Out:
In:
Out:
In:
Out:
In:
Out:
Door
Description
Reader Serial
Numbers
Door Controller
Serial Numbers
I/O Expansion
Serial Number
Linked Camera