Avago Technologies MegaRAID SATA 150-4 (523) - Manual (Page 93)

Screen and Option Descriptions 4-9
Version 2.0 Copyright © 2003–2006 by LSI Logic Corporation. All rights reserved.
4.4.4 Scan Devices Option
When you select the Scan Devices option on the main screen, WebBIOS
checks the physical and logical drives for any changes of the drive status.
WebBIOS displays the results of the scan in the physical and logical
drive descriptions.
4.4.5 SCSI Channel Properties
The SCSI Channel Properties option displays the following information
about the selected SCSI channel (bus):
•
Channel Width (number of bits)
•
Termination (enabled or disabled)
•
SCSI Capabilities (data transfer speed)
4.4.6 Logical Drive Screen
You can access the Logical Drive screen, as shows in Figure 4.4 , by
clicking a logical drive in the logical drive list on the main screen. The
Logical Drive screen provides options to:
•
Set logical drive policies (read, write, I/O, virtual sizing)
•
Initialize the logical drives
•
Check consistency
•
Display the logical drive properties
•
Remove a physical drive from an array
•
Delete a logical drive
•
Select drive migration only or drive migration with addition
You can press Go to perform the selected action or Reset to delete
any changes.