Avago Technologies MegaRAID SATA 150-4 (523) - Manual (Page 122)

5-20 Start the Power Console Plus Utility
Version 2.0 Copyright © 2003–2006 by LSI Logic Corporation. All rights reserved.
5.5.2 Choosing an Adapter
Click the Adapter box and select the adapter that you want to configure.
5.5.3 Running the Configuration Wizard
Follow these steps if the RAID system is already operating and you
would like to reconfigure the adapter.
Step 1. Select Rescan from the Adapter menu to ensure that the
Power Console Plus utility recognizes all the physical drives.
Step 2. Select Wizard from the Configuration menu.
The Wizard screen appears as follows.
Step 3. Select Custom or Automatic.
Step 4. Click Next.
5.5.3.1 Automatic Configuration
If you chose Automatic Configuration, Power Console Plus displays the
proposed RAID configuration in the Logical Devices window. Each logical
drive has a label (such as
LD1 ), RAID level, and drive capacity. Spanned
arrays use hyphenated array numbers, such as LD1-1 . Click the
Redundancy box to instruct the Wizard to configure redundant arrays
when possible. Click Finish to complete the configuration process.
You can click Reclaim to undo the array. Depending on the complexity of
the array, clicking Cancel and repeating the configuration process might be
easier. You can reclaim an array only if there are no logical drives defined.
Follow these steps to reclaim an array that has defined logical drives:
Step 1. Undo the logical drive on the Logical Drive Definition screen.
Step 2. Click Back to display the Array Definition screen.
Step 3. Select the array to be reclaimed.
Step 4. Click Reclaim.