Avago Technologies MegaRAID SATA 150-4 (523) - Manual (Page 110)

5-8 Start the Power Console Plus Utility
Version 2.0 Copyright © 2003–2006 by LSI Logic Corporation. All rights reserved.
Step 5. Click Install to begin installation.
Step 6. Select the destination directory path. The default destination
directory is
C:\Program Files\MegaRAID .
Step 7. Set and verify the password.
Step 8. Edit the REGSERV.DAT and HOSTS files. The installation
retrieves the files for editing. The REGSERV.DAT file is located
at:
C:\winnt\system32\drivers\etc . The HOSTS file is
located at: C:\winnt\system32\drivers\etc. To edit the
files, replace the localhost name with the Registration
Server name.
The HOSTS.DAT file information varies depending on the type of
installation. Enter the IP address and name of all the MegaRAID
servers, including the Registration Server. For example:
123.123.234.1 MegaRAID Server A
123.123.234.2 MegaRAID Server B
123.123.234.3 MegaRAID Workstation C
All specified systems must conform to the TCP/IP specification.
Press ENTER after you type all names of the servers.
Step 9. Save the file and exit.
Step 10. Reboot your system.
Step 11. Proceed to Section 5.3.1.3, “Installing the Windows
SNMP Agent.”
5.3.1.3 Installing the Windows SNMP Agent
After installing the Power Console Plus software, you must install the
Windows SNMP agent. This section provides installation steps for the
Windows SNMP agent on a Windows 2000, Windows XP, and
Windows Server 2003 system. Before installing the SNMP agent, verify
that all LAN cards are configured with TCP/IP and ping all the IP
addresses to verify the connections.
SNMP Installation on the Windows 2000, Windows XP, and
Windows Server 2003 Operating Systems – The following
instructions install SNMP services and verify the SNMP services on a
Windows 2000, Windows XP, and Windows Server 2003 system. You
must install SNMP services for the LSI SNMP agent operate properly.