Avago Technologies MegaRAID SATA 150-4 (523) - Manual (Page 65)

Detailed Configuration Instructions 3-17
Version 2.0 Copyright © 2003–2006 by LSI Logic Corporation. All rights reserved.
You need to update the configuration data in either the NVRAM or on the
hard disk drive. Perform the following steps to resolve the mismatch.
Step 1. Press CTRL+M when prompted during bootup to access the
BIOS Configuration Utility.
Step 2. Select Configure
→
View/Add Configuration.
This gives you the option to view both the configuration on the
NVRAM and the hard drive disk.
Step 3. Select either NVRAM or configuration on disk.
Step 4. Press ESC and select YES to update the configuration data.
Step 5. Press ESC to exit, then reboot.
3.4.3 Starting MegaRAID Manager
MegaRAID Manager runs under the following operating systems:
•
MS-DOS
•
NetWare
•
Red Hat Linux
Note: For more information about these operating systems and
driver installation, refer to the MegaRAID Device Driver
Installation User’s Guide.
To start MegaRAID Manager, ensure the program file is in your file path.
In DOS, type:
MegaConf
In NetWare, type:
load megamgr
For any other operating system (OS), refer to the documentation that
accompanied the OS.