RIGOL DG5000 Series User Manual
Page 30
RIGOL
User’s Guide for DG5000
1-6
1. Power Key
The power soft key is used to turn the generator on or off.
2. USB Host
Support USB storage device,
RIGOL DS1000E series digital oscilloscope (DS) and
power amplifier (PA).
USB storage device: read the waveform or state files from the USB storage
device, or store the current instrument state and edited waveform data into
the USB storage device.
DS1000E series DS: seamlessly interconnect with the
RIGOL DS1000E series
DS, read and store the waveform data sampled by the DS and display it
nondestructively.
PA (optional): support the
RIGOL power amplifier, for example, PA1011.
Enable to be configured online and amplify the signal power before output.
3. LCD
480 × 272 TFT color LCD is used to display the current function menu and
parameters setting, system state and prompt messages.
4. Display Switch
For dual-channel model: this key is used to switch between Parameter and Graph
display modes.
For single-channel model: this key is not available.
5. Sine
Generate a Sine waveform with frequency from 1 μHz to 350 MHz.
When the function is enabled, the backlight of the button turns on.
Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level
and Start Phase of the Sine waveform.
6. Square
Generate a Square waveform with frequency from 1 μHz to 120 MHz and variable
duty cycle.
When the function is enabled, the backlight of the button turns on.
Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level,
Duty Cycle and Start Phase of the Square waveform.