RIGOL DG5000 Series - Manual (Page 138)

RIGOL Chapter 8 FH Output (Option)
User’s Guide for DG5000 8-8
To Edit List
Press Edit List  Edit Point to open the
list editing interface.
1. Press Current Point, use the numeric keyboard or the knob to input the No. of
the point to be edited (i.e. n in the figure above), and this No. is limited by the
points of the current list.
2. Press Current Freq, use the numeric keyboard or the knob to input the
frequency of the current point (i.e. f
n
in the figure above), and this value is limited
by the maximum output frequency of the generator.
3. Press Return, finish point editing and return to the previous menu.
Press Save to open Store/Recall interface, save the edited FH
list. For detailed
introduction, please refer to “ Store and Recall”.
To Create List
Press New List to open
list create interface.
1. Press List Points and use the numeric keyboard or the knob to input initial points.
The initial points could be up to 4096.
2. Press Edit Point to open the table edit interface.
 Press Current Point, use the numeric keyboard or the knob to input the No.
of the point to be edited, and this No. is limited by the current initial points.
 Press Current Freq, use the numeric keyboard or the knob to input the
frequency of the current point, and this value is limited by the maximum
output frequency of the generator.
 Press Return, finish point editing and return to the previous menu.
3. Press Save to open Store and Recall Interface, save the created FH list. For
details, please refer to the introduction in “ Store and Recall”.