RIGOL DG5000 Series - Manual (Page 171)

Chapter 10 Advanced Operation RIGOL
User’s Guide for DG5000 10-21
Print
Users could store the screen graph into external USB storage device or print it using
PictBridge printer. Press Utility  Print to open print setting interface.
1. To Print Screen to PictBridge Printer
Connect the PictBridge printer first. Use USB cable to connect the USB Device
interface of the generator to the USB Host interface of the printer (as shown in
the figure below).
Set the Device Type to “Printer” (refer to To Set USB Device Type) and press
Pict Bridge to enter the setting interface.
 Print: prints the screen after 10 seconds you press the key.
 Copies: specifies the required number of copies to be printed by using the
knob. The maximum is 9999 copies.
 Palette: selects the picture color from “Gray” or “Color”.
 Inverted: enables or disables the inverse print.
2. To Store Screen to USB Storage Device
Please connect a USB storage device first. When the connection succeeds, an
icon will be displayed on the status bar of the screen and the
corresponding prompt message will be displayed on the screen.
Press U Disk, a clock icon and a countdown prompt (10 s) will appear on the left
of the icon. Switching the screen to your desired image within the
specified time, the generator will automatically store the image under the folder
named “Rigol” (created automatically if it do not exist) in the USB storage device
in bitmap form (*.BMP). If the storage operation succeeds, the screen will display
corresponding prompt message.
DG5000 PictBridge Printer
USB Host USB Device
USB Cable