RIGOL DG5000 Series - Manual (Page 150)

RIGOL Chapter 9 Store and Recall
User’s Guide for DG5000 9-10
Seamlessly Interconnection
DG5000 could interconnect with the
RIGOL DS1000E series digital oscilloscope
seamlessly to rebuilt and output the waveform data collected from the oscilloscope
losslessly.
1. Make sure the measured signal is displayed stably on the screen of DS1000E.
2. Connect the USB Host interface of DG5000 to the USB Device interface of
DS1000E. Now, DS1000E will enter “Remote” mode automatically.
3. Press Store/Recall key at the front panel of DG5000 to enter Store/Recall
interface. The model identifier of DS1000E will appear in the “Directory Display
Area” (refer to Figure 9-1).
4. Use the knob of DG5000 to move the focus cursor onto the model identifier of
DS1000E. All channels and their on/off status of DS1000E will be displayed in the
“File/Folder Display Area”.
5. Set the Browser of DG5000 as “File”, and move the cursor onto the channel to be
read, and then press Read. DG5000 will automatically switch to arbitrary
waveform mode (Arb) and load the waveform collected by DS1000E to the
internal volatile memory of DG5000. Meanwhile, in order to protect the measured
circuit, DG5000 will automatically turn off its output. When the user confirms that
the current output will not damage the measured circuit and turns on the channel
switch of DG5000, the generator will output the arbitrary waveform collected by
DS1000E. Connect the output of DG5000 to the input of DS1 and configure DS1 to
view the waveform collected by DS1000E.
Tips: The waveform data collected by the oscilloscope is stored circularly, thus the
data read by DG5000 is also finite and exists discontinuousness in phase. We
recommend that you display interested signal fragment in the oscilloscope screen
stably, and then use DG5000 to read the data and then output through burst (Burst)
mode.
DG5000 DS1000E DS1
USB Device USB Host Output Input
USB Cable BNC Cable
The measured signal