RIGOL DG5000 Series - Manual (Page 190)

RIGOL Chapter 10 Advanced Operation
User’s Guide for DG5000 10-40
To Configure the Remote Interface
DG5000 is furnished with USB, GPIB (IEEE-488) and LAN interfaces. Users can
configure the remote interface parameters (USB parameters needn’t to be configured)
to control DG5000 remotely.
Press Utility  I/O Setup to open the interface setting menu. You can set the GPIB
address or LAN interface parameters or select the type of device connected to the USB
interface.
To Set GPIB Address
Each device on the GPIB (IEEE-488) interface must have a unique address.
Press Utility  I/O Setup  GPIB Address, and use the numeric keyboard or the
knob to set the GPIB address as a value within 0 and 30, the default value is “2”. The
selected address is stored in nonvolatile memory.
LAN Setting
Press Utility  I/O Setup  LAN to open the LAN parameters configuration
interface as shown in the following figure. You could examine the LAN status and
configure the LAN parameters.
Figure 10-4 LAN Setting Interface
Current IP Configure Mode
Network Status
IP Configure Mode status
MAC Address
VISA Descriptor