RIGOL DG5000 Series - Manual (Page 152)

RIGOL Chapter 10 Advanced Operation
User’s Guide for DG5000 10-2
Advanced Operation Overview
Press Utility at the front panel to open the advanced operation interface as shown
below. The interface presents the current output configurations of the channels, GPIB
address, Clock Source, Base Source and Frequency/Phase Deviation of Channel
Coupling, Language and Power On value.
Figure 10-1 Advanced Operation Interface
1. CH1 Set: set the output parameters of CH1.
2. CH2 Set: set the output parameters of CH2.
3. PA Setup: set the parameters of the power amplifier. Only available when the PA
is installed.
4. I/O Setup: set the I/O interface parameters.
5. System: set the system parameters.
6. Print: store the screen information in external USB storage device or print it
using PictBridge printer.
7. Test/Cal: enter the system Test or Calibration operation.
8. Coupling: enter the Channel Coupling operation.
9. Copy Channel: enter the Channel Copy operation.
10. Digital: select the work mode of the digital module: “Power On” or “Power Off”.
Only available when the digital module is installed.