RIGOL DG5000 Series - Manual (Page 188)

RIGOL Chapter 10 Advanced Operation
User’s Guide for DG5000 10-38
 Press AnalogCh to select On or Off. When On is selected, the analog
channel voltage (1.4V to 4.9V) of the digital module can be set and when
“Off” is selected, the analog voltage output is turned off.
Note: When analog channel voltage is adjusted higher than 4.2V, digital channel
voltage is automatically adjusted to be 3/8 of analog channel voltage. While,
when adjusting digital channel voltage, analog channel voltage is automatically
set to the same value as digital channel voltage.
Trigger Setting
The digital module provides two trigger modes: Auto and Burst.
Auto Trigger: default trigger mode. At this point, users can press TrigInt and use
the knob or number keypad to set the interval time and the range available is from 0s
to 30s.
Burst Trigger: press Burst  Source to select “Internal”, “External” or “Manual”.
For details, refer to the introductions in “Burst Trigger Source”. Note, at this point,
trigger interval cannot be set.
Tip
For specifications of digital module, refer to “Appendix C: Specifications of
Digital Module”.