RIGOL DG5000 Series - Manual (Page 220)

RIGOL Chapter 14 Appendix
User’s Guide for DG5000 14-4
Appendix C: Specifications of Digital Module
Unless otherwise noted, all the specifications are applicable to the digital modules of
DG5000 series function/arbitrary waveform generator. All the specifications can be
guaranteed if the following two conditions are met.
 The generator has been working continuously for 30 minutes at specified
temperature.
 Open the system function menu and execute “Test Calibration” if the operating
temperature is equal to or more than 5℃.
Common Specifications
Digital Voltage Range
1.4～4.2V (Typical value and user-defined value) (except RS232)
Trigger Mode Auto trigger and burst trigger
Code Pattern ALL_0, ALL_1, 01, PRBS, User
User Space 256k Bytes in-line editing, 2M Bytes output (PC editing)
Parameters and Specifications relating to PO Protocol
Analog Voltage Range
1.4～9.4V
Clock (CLK) Line C0 and C1 (selectable)
Clock Phase 0 0 , 90 0 , 180 0 , 270 0 (adjustable)
Data Line D0～D15 (selectable)
Transmission Rate 1bps～100Mbps (adjustable)
Output Data Range 1Byte～128k Bytes (selectable)
Mask Channel Setting None, D0～D15 (selectable)
Tri-state Channel Setting None, D0～D15 (selectable)
Parameters and Specifications relating to IIC Protocol
Analog Voltage Range
1.4～9.4V
Bit Order MSB
Clock (CLK) Line D0～D15 (selectable)
Data Line D0～D15 (selectable)
Transmission Rate 1bps～15Mbps (adjustable)
Output Data Range 1Byte～10k Bytes (selectable)
Output Address (selectable) None or 7bits address
Operation Mode
When selecting address output, select read or write mode
Parameters and Specifications relating to SPI Protocol