RIGOL DG5000 Series - Manual (Page 157)

Chapter 10 Advanced Operation RIGOL
User’s Guide for DG5000 10-7
Attenuation Setting
This setting will attenuate (amplifier) the current amplitude following specified ratio
and output the waveform. The available attenuation ratios include 1X, 2X, 5X and 10X.
Press Utility  CH1Set  Attenuat to select desired ratio.
For example, if the current amplitude is “5 Vpp”, change the Attenuation Setting from
“1X” to “2X”, and the displayed amplitude on the screen will change to “2.5 Vpp” but
the real output is still “5 Vpp”.
Enable Freq Hop Function
DG5000 could output Frequency Hopping (FH) waveform from the single channel or
the two channels at the same time.
Press Utility  CH1Set (or CH2Set) at the front panel, use
to open the 2/2
menu page, press FreqHop to enable FH function of CH1 (or CH2).
For detailed introduction about FH function, please refer to “FH Output (Option)”.