RIGOL DG5000 Series - Manual (Page 197)

Chapter 11 Remote Control RIGOL
User’s Guide for DG5000 11-1
Chapter 11 Remote Control
At least two means can be used to control DG5000 in Remote Mode:
User-defined programming
Users can program and control DG5000 by using the SCPI (Standard Commands for
Programmable Instruments) commands. For more information about the commands
and programming, refer to the Programming Guide.
Use PC software
Users can use the PC software Ultra Sigma (from
RIGOL) to send SCPI commands
to control DG5000 remotely.
DG5000 can communicate with PC through USB, LAN and GPIB interfaces. This
chapter will give a detailed introduction of how to use Ultra Sigma to control DG5000
remotely through various interfaces. To get the Ultra Sigma software and detailed
operation instruction, please contact
RIGOL.
Subjects in this chapter:
 Remote Control Via USB
 Remote Control Via LAN
 Remote Control Via GPIB