Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Manual (Page 143)

5 Adjustments
5.1.3 Monitoring Analog Signals
5-6
(2) Setting Monitor Factor
The output voltages on analog monitor 1 and 2 are calculated by the following equations.
(3) Related Parameters
Use the following parameters to change the monitor factor and the offset.
Analog monitor 1 output voltage = (-1)
×
Analog monitor 2 output voltage = (-1)
×
(Pn006=n.00 غغ ) (Pn552)
(Pn007=n.00 غغ
×
Multiplier + Offset voltage [V]
×
Multiplier + Offset voltage [V]
(Pn550)
(Pn551) (Pn553)
Signal selection
Signal selection
Pn550
Analog Monitor 1 Offset Voltage
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.1 V 0 Immediately Setup
Pn551
Analog Monitor 2 Offset Voltage
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.1 V 0 Immediately Setup
Pn552
Analog Monitor Magnification ( ×1)
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.01 times 100 Immediately Setup
Pn553
Analog Monitor Magnification ( ×1)
Classification
Setting Range Setting Unit Factory Setting When Enabled
-10000 to 10000 0.01 times 100 Immediately Setup
Speed Position Torque
Speed Position Torque
Speed Position Torque
Speed Position Torque